Rear Shock Mount Sizes Explained: 8x20, 8x22, 8x24, 8x25
StarswheelIf you are replacing a rear shock, the length is the easy part — it is stamped on the old unit or listed in your frame's spec sheet. The mounting bore is the part that stops people. It is never printed anywhere, it changes between frames that look identical, and getting it wrong means the shock simply will not bolt on.
This page is the reference we wish existed when we started sourcing these.
What "mounting bore" actually means
The bore is the hole in the eyelet at each end of the shock — the hole the mounting bolt passes through. It has two numbers that matter: the bolt diameter (almost always 8mm on modern MTB and e-MTB frames) and the eyelet width (how wide the eye is, which sets how long the spacer stack has to be).
Written as a spec, that is 8 × 24mm: an 8mm bolt through a 24mm wide eye.
Measure the inside diameter with calipers. Measuring the outside of the eye tells you the outer diameter, which is a different number and completely useless for fitment.
The four bores you will actually run into
| Bore | Where it turns up | What to do |
|---|---|---|
| 8 × 20mm | Plenty of older XC and trail frames, some hardtails converted to full suspension geometry | A 24mm shock will not clamp down. The gap is too wide to shim out safely. |
| 8 × 22mm | Some trail frames and a handful of e-MTBs | 2mm out. Sounds close. It is not close. |
| 8 × 24mm | Our coil shock range, and a good number of e-MTB and DH-adjacent frames | Direct fit. |
| 8 × 25mm | Several downhill frames and some heavier e-MTBs | 1mm out on the wide side. Some setups can be shimmed, most cannot be done safely. |
Why length gets measured and bore gets ignored
Because length is a number you can look up. Bore requires taking the shock off, finding calipers, and measuring something with no label on it. So people order by length, receive the part, and then discover the eye is the wrong width when the bolt will not pass through or the eye rattles.
We have seen this enough times that it is now the first thing we ask anyone who emails us before ordering: what is the bore at both ends?
Can you adapt a different bore?
A little, sometimes. Bushings and shims can absorb a fraction of a millimetre — think 0.5mm, not 2mm. If your frame is 8 × 22mm and the shock is 8 × 24mm, there is no adapter in the world that closes that gap properly, and anyone selling you one is selling you a part that will develop play.
If your frame is 8 × 25mm and the shock is 8 × 24mm, a thin shim on each side is physically possible on some frames. Whether it is safe depends on how the shock is clamped. We will not tell you it is fine without seeing the frame.
Bore is not the only number — but it is the one that kills the sale
You still need eye-to-eye length and stroke to match. Get those right and the bore wrong and you have an expensive paperweight. Get the bore right and the length wrong and you have a shock that will not fit either. All three, or none.
If you are not sure how to measure any of them, our sizing guide walks through all three with the numbers written out.
What our range uses, and why we say it loudly
Every coil rear shock we stock is 8 × 24mm at both mounting points, in 165, 190, 210, 240 and 265mm eye-to-eye. No adapter is included and the bore cannot be changed.
We put that in the first paragraph of every listing rather than in a footnote, because the alternative — a customer ordering, waiting two weeks for a parcel from China, and finding out it does not fit — costs both of us far more than a lost sale.
See the full range by eye-to-eye length, or if your bore is not 8 × 24mm, we would genuinely rather you did not order.