Rear Shock Sizing Guide: Eye-to-Eye, Stroke and Bore

Three numbers decide whether a rear shock fits: eye-to-eye length, stroke, and the bore at both mounting points. Length is printed on the old shock. Bore is not — it has to be measured.

1. Eye-to-eye length

Centre of the top eyelet to centre of the bottom eyelet. Not the overall length, and not the body length. With the shock still on the bike you can usually get close, but pulling it off and measuring flat on a bench is what you want before spending money.

2. Stroke

How far the shaft travels. Commonly marked near the shaft, or listed in your frame's spec sheet. Our range: 165mm/35mm, 190mm/45mm, 210mm/50mm, 240mm/65mm, 265mm/85mm.

3. Mounting bore

This is the one people get wrong. Use calipers on the inside diameter of the eyelet, not the outside, and check both ends — they are usually the same but not always.

Bore Common on
8 × 20 mm Many older XC and trail frames
8 × 22 mm Some trail and e-MTB frames
8 × 24 mm Our coil shock range
8 × 25 mm Several downhill and some e-MTB frames

Bushings and shims can take up a fraction of a millimetre. They cannot take up 2mm. If your bore is not 8 × 24mm, our shocks will not fit and no adapter is included.

4. Spring rate

Set by rider weight and your frame's leverage ratio. Two riders of the same weight on different frames can need different rates, which is why we do not publish a weight-to-rate table — it would be a guess presented as advice. If you tell us your frame and weight we will ask the supplier rather than invent a number.

5. Check your numbers against the range