How to Measure Rear Shock Eye-to-Eye Length (Without Guessing)
StarswheelEye-to-eye length is the single most important number when replacing a rear shock, and it is also the one most often measured wrong — usually because someone measured the whole shock instead of the distance between the mounting holes.
What eye-to-eye means
Centre of the top eyelet to centre of the bottom eyelet. That is it. Not the overall length including the eyelets, not the body length, not the shaft length.
If you measure from the outside edge of one eye to the outside edge of the other, you will be about one eyelet diameter too long — which on this hardware is roughly 10mm of error. That is the difference between a shock that fits and one that does not.
How to measure it properly
- Take the shock off the bike. You can get close with it mounted, but "close" is not what you want before spending money.
- Lay it flat on a bench. No angle, no sag, nothing preloading the shaft.
- Mark the centre of each eye. A scribe or a fine marker through the bolt hole is enough.
- Measure centre to centre. Calipers or a steel rule, flat against the bench.
- Check against the old shock's markings. Most shocks have the length and stroke printed on the body or the spring. If your measurement and the stamp disagree, the stamp is usually right — it is the manufacturer's own number.
What about stroke?
Stroke is how far the shaft travels, and it usually goes with length rather than independently. Our range runs 165mm/35mm, 190mm/45mm, 210mm/50mm, 240mm/65mm and 265mm/85mm.
You generally cannot substitute a longer stroke shock onto a frame designed for a shorter one — the tyre or the frame will hit before the shock bottoms out. Match stroke as well as length.
What happens if you are 2mm off
On some frames, nothing: there is enough clearance in the linkage that 2mm of extra length just raises the rear slightly. On others, 2mm is enough to change the head angle, load the linkage bearings in a direction they were not designed for, or let the tyre contact the seat tube at full compression.
We are not going to tell you 2mm is fine, because we do not know your frame. What we will say is that the frame manufacturer designed around one number and it is worth matching that number.
The mistake that costs the most
Not measuring the bore. Length is on the spec sheet, bore is not — so people order by length and get caught by the eyelet width. Our shocks are 8 × 24mm at both ends, and plenty of frames run 8 × 20, 8 × 22 or 8 × 25mm.
We wrote a whole separate piece on that: Rear shock mount sizes explained. Read it before you order anything from anyone, not just from us.
Once you have your three numbers
Length, stroke, bore. With those in hand, the range is sorted by eye-to-eye length so you can go straight to yours. And if your bore turns out not to be 8 × 24mm, tell us — we would rather lose the sale than send you something that will not fit.